Open Access Open Access  Restricted Access Subscription Access

Manufacturing of Aircraft Wing Stiffeners Using 4D Printing of Composites

SUONG VAN HOA, BHARGAVI REDDY, DANIEL IOSIF ROSCA

Abstract


This paper presents the procedure to make omega stiffeners using the method of 4D printing of composites. The method allows the manufacturing of complex structures without the need for a complex mold. Instead, flat layers of composite prepregs are laid on a flat mold. Due to the anisotropy of the different layers in the laminates, the stack of prepregs will change from its flat configuration into the omega shape upon curing and cooling to room temperature. The cavity is filled with foam to make the final structure.


DOI
10.12783/asc36/35752

Full Text:

PDF

References


Hoa Suong Van, “Factors affecting the deformation of laminates made using 4D printing of

composite methodâ€, Journal of Advanced Manufacturing: Polymers & Composites Science,

Hoa Suong V., “Development of composite leaf springs using 4D printing of compositesâ€,

Composite Structures, 2018.

Hoa Suong V., and Rosca D.I., “Formation of the word CONCORDIA using 4D printing of

compositesâ€, Materials Today Communications, 2020.

https://www.oreilly.com/library/view/design-andanalysis/

/OEBPS/9781118536940_epub_c_08.htm.

F. Elaldi, S. Lee, and R.F. Scott, “Manufacturing of composite panels with J-shape stiffenersâ€,

Journal of Materials and Manufacturing processes, 10, 1, 27-36, 1995.

Hoa S.V., Reddy B., Rosca D.I., “Development of omega stiffeners using 4D printing of

compositesâ€, Composite Structures, Vol. 272, September 2021, 114264.


Refbacks

  • There are currently no refbacks.